RAD-A2B Specifications
General Specifications
- Interface to PC via 1G Ethernet or Isolated USB 2.0 (240 Mb/s)
- Low power consumption
- Power supply: 6-40V operation via barrel jack; use included power supply or vehicle power
- Ten scriptable, multi-color LEDs indicate link status and modes of operation
- Temperature range: -40°C to +85°C
- One-year limited warranty
- Field-upgradeable flash firmware
- Standalone mode, including scripting, receive messages, transmit messages, expressions, I/O and transport layers
- Dimensions: 5.41” × 3.43” × 1.43” (13.7 × 8.72 × 3.62 cm)
- Weight: 0.65 lb (295 g)
Timing Specifications
- FPGA-measured 64-bit timestamping with 10 ns accuracy on all CAN FD networks
- Simultaneous operation on all CAN FD networks
Network Specifications
- AD2433 for the A2B transceiver
- 1x A2B Monitor
- 1x A2B Emulator (transmit and receive) Node
- 2x CAN / CAN FD channels: two dedicated ISO11898 Dual Wire CAN physical layers (TJA1043T)
- Software-switchable between ISO CAN FD and non-ISO (Bosch) CAN FD versions
- Up to 1 Mb/s software-selectable baud rate for arbitration phase
- Up to 8 Mb/s software-selectable baud rate for data phase
- Listen-only mode support
- CAN FD implemented using the Bosch MCAN CAN controller IP
- Software-selectable termination resistors for CAN channels
- 1x LIN (Local Interconnect)
- Full support for LIN 1.X, 2.X and J2602
- LIN J2602 / 2.X compatible physical layer
- Software enabled 1K LIN Master Resistor per channel
- LIN Bus Monitor Mode identifies errors: Sync Break Error State and Length, Sync Wave Error, Message ID parity, TFrameMax/ Slave Not Responding, Checksum Error and Transmit Bit Errors
- LIN Bus Master Mode operates at same time as LIN Bus Monitor
- LIN Bus Slave simulation – with or without an LDF file
- LIN Bus hardware schedule table with support for LIN diagnostics
- Software-selectable baud rate
Ordering Information
| Part Number | Description |
| RAD-A2B | Automotive Audio Bus and Network Monitoring Solution |
Specifications subject to change; please contact Intrepid for the latest information. All trademarks are the property of their respective owners.
